Gen 2 · Precision curing United States / USD
ShopDashboard loginOrdersCart 0

From installation
to your first cure.

Starting guidance from the Gen 2 Operating Manual.

Aim for 61–64°F (16–18°C) and room humidity below 55% RH. Cure Puck exchanges room air; it does not actively dehumidify. The room must be drier than the container target.

Use a compatible threaded opening or a 2-3/8" (60 mm) hole. Keep the gasket between the Cure Puck and container; tighten the nut by hand to compress the gasket about 3/16" (5 mm). Keep the probes above the flower and the diffuser at the bottom.

Seal representative samples with an accurate humidity meter. Wait at least 30 minutes and until readings stabilize. The manual gives 61–64% RH as an entry range, with 63% as a starting reference; adjust for cultivar and your process. Never bury the probes.

Open Settings → AutoCure → Advanced. Turn AutoCure on and lock VPD. Choose the VPD target for your room temperature using the calculator. Enable CO₂ exchange and set a limit between 800 and 1,200 ppm. Set cure duration for your batch.

Install Cure Puck from your phone’s app store, create your account and choose Add Device. For a new device, open Settings → Network → Provision Mode. Use the same account at dashboard.curepuck.io to see history and configure notifications.

AutoCure runs when enabled. The Play button starts additional timed burps; the Pump icon starts a manual burp. Set email/SMS notifications in the web dashboard as well as enabling the device alerts. Continue routine batch checks.

Ask about your setup

Parts and equipment for your setup

Find the listed parts and equipment, or contact support to confirm compatibility with your supplied unit.

Continue exploring